Did your throttle position sensor wiring get brittle, melted, or damaged? This pre-wired 6-pin TPS connector pigtail is an easy fix. It comes with about 7.5 inches of wire, so you have enough length to splice into your existing harness. The connector is built to withstand extreme temps (from -60°C to 200°C) and is waterproof and dustproof for reliable performance under the hood. It matches OE standards for a perfect fit onto your sensor. Just cut the old connector off, solder or crimp the new wires, and seal it up. Saves you from buying a whole new sensor when just the wiring is bad. A must-have for DIYers tackling engine repairs, especially on older vehicles where plastic connectors get crispy. Keep your throttle response smooth and your check engine light off.
